2. Install the heat sink.
3. Install the base cover.
4. Install the SIM card tray.
5. Install the SD card.
6. Follow the procedure in After working inside your computer.
Power button with fingerprint reader assembly
Removing the power button with fingerprint reader assembly
Prerequisites
NOTE: For system shipped with power button with fingerprint reader assembly only.
1. Follow the procedure in Before working inside your computer.
NOTE: Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your
computer.
2. Remove the SD card.
3. Remove the SIM card tray.
4. Remove the base cover.
5. Remove the heat sink.
6. Remove the display assembly.
7. Remove the I/O daughter board.
About this task
The following images indicate the location of the power-button and provide a visual representation of the removal procedure.
Steps
1. Gently disconnect the power button with fingerprint reader FPC cable from the connector on the USH daughter board.
52
Removing and installing components
To Next Page
Loading...
