Dell Latitude 9430 2-in-1 - Installing the Solid-State Drive

Installing the solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the solid-state drive and provides a visual representation of the installation
procedure.
Steps
1. Align the notch on the solid-state drive with the tab on the M.2 card connector.
2. Slide the solid-state drive into the M.2 card connector on the system board.
3. Replace the single (M1.6x2.5) screw that secures the solid-state drive to the system board.
4. Place the thermal pad and adhere it on the solid-state drive card.
5. Align and place the solid-state drive shielding cover, press to fit it firmly to cover the solid-state drive.
Next steps
1. Install the base cover.
2. Install the SIM card tray.
3. Install the SD card.
4. Follow the procedure in After working inside your computer.
Removing and installing components
23