5. Remove the WWAN card.
6. Remove the battery.
About this task
The following images indicate the location of the WLAN antenna module and provide a visual representation of the removal
procedure.
Steps
1. Remove the single (M1.6x1.8) screw securing the Proximity sensor bracket to the plam-rest assembly and lift the Proximity
sensor bracket off the system.
2. Peel off the piece of tape securing the WLAN antenna module's proximity sensor cable in place.
3. Disconnect the WLAN antenna module's Proximity sensor cable from the RF board and unroute the Proximity sensor cable
from the routing guides.
Removing and installing components
47
To Next Page
Loading...
