a. Lift the mylar tape and disconnect the low-voltage differential signaling (LVDS) cable from the
back of the display panel.
b. Remove the display panel from the display assembly.
Installing the Display Panel
1. Place the display panel to the display assembly.
2. Align the display panel in its original position.
3. Connect the low-voltage differential signaling (LVDS) cable to the display panel and attach the tape.
4. Flip the display panel over and tighten the screws to secure the display panel.
5. Install:
a. display bezel
b. battery
6. Follow the procedures in After Working Inside Your Computer.
Removing the Camera
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a. battery
b. display bezel
3. Perform the following steps:
a. Remove the screw that secures the camera and microphone module.
b. Disconnect the camera cable.
c. Lift and remove the camera and microphone module.
14
To Next Page
Loading...
