4. After removing the optical-drive bracket, perform the following steps:
a. Remove the screws that secure the optical-drive bracket [1].
b. Remove the optical-drive bracket from the optical drive [2].
5. Disengage the optical drive bezel tabs to separate the optical drive bezel from the optical drive.
6. Remove the optical-drive bezel.
Installing the Optical Drive
1. Engage the optical-drive bezel tabs to attach the optical-drive bezel to the optical drive.
2. Install the optical-drive bracket.
3. Tighten the screws to secure the optical-drive bracket.
4. Insert the optical drive into the computer.
5. Tighten the screw to secure the optical drive in its place.
6. Install:
a. base cover
b. battery
7. Follow the procedures in After Working Inside Your Computer.
19
To Next Page
Loading...
