Installing the System Board
1. Align the system board into its original position on the computer.
2. Replace and tighten the screws to secure the system board to the computer.
3. Connect the following cables:
a. I/O board cable
b. power-connector cable
c. status-light board cable
4. Turn over the computer and connect the coin-cell battery cable and speaker cable to the system
board.
5. Install:
a. ExpressCard cage
b. system fan
c. palmrest
d. display hinge
e. WLAN card
f. hard drive
g. optical drive
h. memory
i. keyboard
j. keyboard trim
k. base cover
l. battery
m. SD card
6. Follow the procedures in After Working Inside Your Computer.
33
To Next Page
Loading...
