Installing the Palmrest
1. Align the palmrest assembly to its original position in the computer and snap it into place.
2. Connect the following cables to the system board:
a. power-button cable
b. fingerprint-scanner cable
c. touch-pad cable
d. media button cable
3. Tighten the screws to secure the palmrest at the front and back of the computer.
4. Install:
a. display hinge
b. hard drive
c. optical drive
d. memory
e. keyboard
f. keyboard trim
g. base cover
h. battery
i. SD card
5. Follow the procedures in After Working Inside Your Computer.
Removing the Display Assembly
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a. SD card
b. battery
c. base cover
d. keyboard trim
26
To Next Page
Loading...
