Installing the speaker
1. Insert the speaker into the slot and press it until it clicks into place.
2. Connect the speaker cable to the connector on the system board.
3. Install the:
a. hard drive and optical drive module
b. bezel
c. cover
4. Follow the procedure in After working inside your computer.
Intrusion switch
Removing intrusion switch
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. cover
3. To remove the intrusion switch:
a. Disconnect the intrusion switch cable from the connector on the system board [1][2].
b. Slide the intrusion switch and lift it away from the computer [3].
Removing and installing components
15
To Next Page
Loading...
