b. Press the power switch retention tabs and pull out from the computer [2] [3].
Installing the power switch
1. Slide the power switch module into the slot on the chassis until it clicks into place.
2. Connect the power switch cable to the connector on the system board.
3. Install the:
a. hard drive and optical drive module
b. bezel
c. cover
4. Follow the procedure in After working inside your computer.
System board
Removing system board
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. cover
b. bezel
c. heat sink
d. processor
e. expansion card
f. hard drive and optical drive module
28
Removing and installing components
To Next Page
Loading...
