b. Remove the screws that secure the SD card reader and lift it away from the computer [2] [3].
Installing the SD card reader
1. Place the SD card reader on the chassis.
2. Tighten the screws that secure the SD card reader to the computer.
3. Install the:
a. hard drive and optical drive module
b. M.2 PCIe SSD
c. bezel
d. cover
4. Follow the procedure in After working inside your computer.
Power supply unit
Removing power supply unit or PSU
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. cover
b. bezel
c. hard drive and optical drive module
3. To release the PSU:
a. Disconnect the power cable from the system board [1] [2].
24
Removing and installing components
To Next Page
Loading...
