Dell OptiPlex 9010 Small Form Factor - Component Removal and Installation - Storage; Removing and Installing the Drive Cage

Installing The WLAN Card
1. Insert the WLAN card into the connector on the system board and press down until it is securely in place. Fix the
latch.
2. Place the antenna puck on the connector and tighten the screws that secure it to the computer.
3. Install the cover.
4. Follow the procedures in After Working Inside Your Computer.
Removing the Drive Cage
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the:
a. cover
b. front bezel
11