Dell OptiPlex 9010 Small Form Factor - Component Removal and Installation - Basic Hardware; Recommended Tools; Removing and Installing the Computer Cover

2
Removing and Installing Components
This section provides detailed information on how to remove or install the components from your computer.
Recommended Tools
The procedures in this document may require the following tools:
• Small flat-blade screwdriver
• Phillips screwdriver
• Small plastic scribe
Removing the Cover
1. Follow the procedures in Before Working Inside Your Computer .
2. Pull up the cover-release latch at the side of the computer.
3. Lift the cover upward to a 45–degree angle and remove it from the computer.
Installing the Cover
1. Place the cover on the chassis.
2. Press down on the cover till it clicks into place.
8