Dell P111G - Power-Button Board

Next steps
1 Replace the battery
2 Replace the base cover
3 Replace the SD memory card
4 Follow the procedure in after working inside your computer
Power-button board
Removing the power button board
Prerequisites
1 Follow the procedure in before working inside your computer
2 Remove the SD memory card
3 Remove the base cover
4 Remove the battery
5 Remove the system fan
6 Remove the display assembly
Steps
1 Open the latch and disconnect the power button board cable from the system [1].
2 Unroute the cable from the palmrest and keyboard assembly [2].
3 Peel the conductive tape o the power button board [3].
Removing and installing components
67