Steps
Place the palm-rest and keyboard assembly on a flat and clean surface and perform the post-requisites to install the palm-rest
and keyboard assembly.
Next steps
1. Install the system board.
2. Install the power button or power button with optional FPR.
3. Install the power-adapter port.
4. Install the display assembly.
5. Install the touchpad.
6. Install the hard drive assembly.
7. Install the I/O board.
8. Install the heat sink.
9. Install the fan.
10. Install the speakers.
11. Install the wireless card.
12. Install the memory modules.
13. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive (whichever applicable).
14. Install the 3-cell battery or 4-cell battery (whichever applicable).
15. Install the base cover.
16. Install the SD card.
17. Follow the procedure in After working inside your computer.
104
Removing and installing components
To Next Page
Loading...
