Removing the audio daughter-
board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Prerequisites
1 Remove the base cover.
2 Remove the battery (half-length) or the battery (full-length).
3 Remove the wireless card.
4 Follow the procedure from step 1 to step 4 in “Removing the hard drive”.
5 Remove the solid-state drive (half-length) or the solid-state drive (full-length).
6 Remove the fans.
7 Remove the heat-sink assembly.
8 Remove the memory modules.
9 Remove the system board.
Procedure
1 Remove the two screws (M2x3) that secures the audio daughter-board to the
system board.
64
To Next Page
