Dell PowerConnect 5324 - 10 Device Specifications; Port and Cable Specifications; Operating Conditions; Physical Device Specifications

PowerConnect 5324 Release Notes
System Firmware Version 2.0.0.39 Subject to Change Without Notice Page 9
Interface CoS/QoS Settings
The following Screens has been updated under the QOS section
Remove the following field descriptions.
• Queue — The queue number.
• Queue Mode — Indicates whether the queue is Strict Priority or WRR. This is defined in the Queue Settings
screen.
→ SP can be configured on all queues 1 - 4. This is the default configuration.
→ WRR can be configured on all queues 1 - 4.
→ Two queues on WRR and two queues on SP. The options are as follows: SP mode can be configured on
queues 1 - 2 and WRR on queues 3 - 4
→ WRR mode can be configured on queues 1 - 2 and SP on queues 3 - 4
→ WRR mode can be configured on queues 1 - 3, with SP on queues 4
• Weight (0-255) — Assigns WRR weights to queues. This field is enabled only for queues in WRR queue mode.
• % of WRR Bandwidth — The percentage translation of the weight defined in the Weight (0-255) field.
After the instructions for Assigning QoS/CoS settings for an interface, add the following instructions:
Displaying QoS/CoS settings:
1. Open the Qos/Cos page.
2. Click Show All.
The Interface Table is displayed.