Dell PowerConnect 5324 - Sntp Broadcast Client Enable; MDIX; Port Storm-Control Broadcast Enable; Port Storm-Control Broadcast Rate

PowerConnect 5324 Release Notes
System Firmware Version 2.0.0.39 Subject to Change Without Notice Page 15
sntp broadcast client enable
Update the command as follows:
Field Current Guide Change to:
Dedscription To disable the SNTP anycast client, use
the no form of this command.
To disable the anycast client, use the no form of
this command.
Mdix
Update the command as follows:
Field Current Guide Change to:
Syntax
Parameter
on—Manual mdix on—Enable mdi/mdix
port storm-control broadcast enable
Update the command as follows:
Field Current Guide Change to:
Syntax
Parameter
port storm-control broadcast enable
no port storm-control broadcast enable
port storm-control broadcast enable[ethernet
interface]
no port storm-control broadcast enable
♦ interface—A valid Ethernet port.
port storm-control broadcast rate
Update the command as follows:
Field Current Guide Change to:
Syntax
Parameter
rate—Maximum kilobytes per second of
broadcast and multicast traffic on a port.
(Rate: 0 - 1488095
)
♦ rate—Maximum kilobytes per second of
broadcast and multicast traffic on a port.
(Rate: 0 – 65535
)
User
Guidelines
The granularity is 1 - 64K packets. Note
that if the rate is 0, broadcast packets are
not forwarded.
Delete this guideline.
Example console(config-if)# port storm-control
broadcast rate 10
console(config)# port storm-control broadcast
rate 10