Dell PowerConnect 5324 - Radius-Server Host; D E L E T E D C O M M a N D; M O D I F I E D T E X; Example

PowerConnect 5324 Release Notes
System Firmware Version 2.0.0.39 Subject to Change Without Notice Page 19
radius-server host
Change a parameter description:
Current Guide Change to:
Syntax
Parameter
♦ type—Specifies the usage type of the
server. Can be one of the following
values: login, 802.1x or all. If
unspecified, defaults to all.
♦ type—Specifies the usage type of the
server. Can be one of the following
values: login, dot.1x or all. If
unspecified, defaults to all.
User
Guidelines
Add:
♦ Up to 4 servers can be defined.
Deleted Commands
The following commands are documented but not supported in this release.
• default vlan-disable
• show vlan internal usage
•
ip internal-usage-vlan
Modified Text
Under the heading Editing Features and sub-heading Terminal Command Buffer.
Current Guide Change to:
The standard number of 10 commands
can be increased to 256.
The standard number of 10 commands can be
increased to 216.
Examples:
TAC_PLUS configuration
Note for $enab15$ user setup.
The following user is needed if a user is allowed to go from level 1 to a level 15.
Example.
logs into as user lever then goes to a exec user from console.
console>enable
enter password if console password id enable.
console#
user = $enab15$ {
default service = permit
login = cleartext "15"
service = exec {
priv-lvl = 15
}
}
End of Release Notes