Dell PowerConnect 5324 Release Note

PowerConnect 5324 Release Notes
System Firmware Version 2.0.0.39 Subject to Change Without Notice Page 3
Security
SSH
Title Description ID
Serial connection is lost after 4
concurrent SSH sessions
An attempt to open a forth SSH session will cause the serial
connection to the device to become inactive.
Workaround: Do not open more than three concurrent SSH
sessions.
24773
Deleting SSH generated crypto key Once a key is generated (RSA or DSA), a key cannot be
removed.
Workaround: Erase the flash image and reload.
25047
802.1x
Title Description ID
802.1x authentication does not work
when EAP packets are transmitted
with a VLAN tag = 0
When 802.1x packets are transmitted with VLAN tag = 0, port
cannot authenticate.
Workaround: Do not use VLAN 0 for network configurations.
Switch default VLAN is 1.
23215
Incorrect information displayed in
"Authenticated Users" Web-based
management page
Incorrect information displayed in "Authenticated Users" Web-based
management page with no relevancy to 802.1x status (enabled or
disabled)
Workaround: Use CLI for “Authenticated Users” status.
25857

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2