Dell PowerEdge FC640 - Installing the System into the Enclosure

Figure 7. Installing the I/O connector cover
Next step
Install the system or system blank into the enclosure.
CAUTION
: If you are permanently removing the system, install a system blank. Operating the enclosure for extended periods of
time without a blank installed can cause the enclosure to overheat.
Related link
Installing the system into the enclosure
Installing the system into the enclosure
Prerequisite
CAUTION
: To prevent damage to the I/O connectors, do not touch the connectors or the connector pins.
1 Follow the safety guidelines listed in Safety instructions.
Steps
1 If you are installing a new system, remove the I/O connector cover from the I/O connector(s) and store for future use.
50
Installing and removing system components