Dell PowerEdge FC640 - Page 86

b Insert the battery down into the connector and push the positive side of the battery until the battery snaps into place.
Figure 42. Installing the system battery
Next steps
1 Install the following:
a Drive backplane
b Drives
2 Follow the procedure listed in After working inside your system.
3 Enter the System Setup to conrm that the battery is operating properly.
4 Enter the correct time and date in the System Setup's Time and Date elds.
5 Exit the System Setup.
6 To test the newly installed battery, remove the system from the enclosure, for at least an hour.
7 Reinstall the system into the enclosure, after an hour.
8 Enter the System Setup and if the time and date are still incorrect, see the Getting help section.
Related link
Getting help
Removing the drive backplane
Removing a drive carrier
Removing the air shroud
Installing the drive backplane
Installing a drive carrier
Installing the air shroud
86
Installing and removing system components