Figure 99. Installing the front PERC module to the 2.5-inch drive backplane
Ne
xt steps
1. Connect the cables to the front PERC module.
2. Follow the procedure listed in After working inside your system.
Drives
Removing a drive blank
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. If installed, remove the front bezel.
CAUTION: T
o maintain proper system cooling, drive blanks must be installed in all empty drive slots.
Steps
Pr
ess the release button, and slide the drive blank out of the drive slot.
Figure 100. Removing a drive blank
Installing and removing system components 153
To Next Page
Loading...
