Figure 28. Removing the system cover
Ne
xt steps
Replace the system cover.
Installing the system cover
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system
NOTE: Ensure that all internal cables are connected and routed properly, and that there are no tools or extra parts that are
l
eft inside the system.
Steps
1. Align the tabs on the system cover with the guide slots on the system and slide the system cover.
2. Close the system cover release latch.
NOTE: Ensure that the system cover closes without obstruction or unnecessary force. Reseat any cables or
c
omponents or realign the system cover if necessary.
3. Using a 1/4-inch flat head or Phillips #2 screwdriver, rotate the lock clockwise to the lock position.
I
nstalling and removing system components 85
To Next Page
Loading...
