Dell PowerEdge T560 - Front PERC Module; Removing the Front PERC Module

Table 126. Configuration 56: 24x2.5-inch (SAS4/SATA) fPERC12 + GPUx1 on CPU 2 (continued)
Order From To
12 SL6_CPU1_PB3 (Signal connector on system
bo
ard)
BP_DST_PB1 (Backplane signal connector)
13 SL7_CPU1_PB4 (Signal connector on system
board)
CTRL_DST_PA1 (fPERC 12 connector)
14 SL8_CPU1_PA4 (Signal connector on system
board)
CTRL_DST_PB1 (fPERC 12 connector)
15 BP_DST_SA1 (Backplane 1 signal connector) CTRL_SRC_SA1_PA1 (Signal connector on fPERC 12)
16 BP_DST_SA1 (Backplane 2 signal connector) CTRL_SRC_SB1_PB1 (Signal connector on fPERC 12)
Figure 95. Configuration 57: 8x3.5 -inch ( SAS/SATA) + Optical disk drive + Tape backup unit
Table 127. Configuration 57: 8x3.5 -inch ( SAS/SATA) + Optical disk drive + Tape backup unit
Order From To
1 ODD_PWR (Optical disk drive power
co
nnector on PIB)
ODD (Optical disk drive)
2 DD_PWR (Optical disk drive power connector
on PIB) and CTRL_SRC_SA1 (APERC
connector)
TBU (Tape backup unit) and ODD (Optical disk drive)
3 SL13_PCH_SA1 (Signal connector on system
board
BP_DST_SA1 (Backplane signal connector) and ODD (Optical disk
drive)
Front PERC module
Re
moving the front PERC module
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure that is listed in Before working inside your system .
3. Disconnect all the cables connected to the front PERC module.
150 Installing and removing system components