Figure 24. Removing the system feet
Ne
xt steps
Installing the system feet or install the caster wheels.
Installing the system feet
Prerequisites
CAUTION: I
nstall the feet on a stand-alone tower system to provide stability to the system. An unstable system
might tip over and cause injury to the user or damage to the system.
1. Follow the safety guidelines listed in S
afety instructions.
2. Place the system on its side, on a flat, stable surface.
Steps
1. Align the three tabs on the system foot with the three slots on the base of the system.
2. Using the Phillips #2 screwdriver, tighten the screw that secures the foot to the base of the system.
3. Repeat the preceding step to install the remaining system feet.
Installing and removing system components 81
To Next Page
Loading...
