Figure 26. Removing caster wheels
Next steps
replace the caster wheels or install the system feet.
Installing caster wheels
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Place the system on its side on a flat, stable surface.
3. If installed, remove the system feet.
CAUTION: I
nstall the caster wheels on a stand-alone tower system to provide stability to the system. An
unstable system might tip over and cause injury or damage to the system.
NOTE: This, T series server only uses Dell caster wheels.
Steps
Al
ign the caster wheels to the base of system and tighten the captive screw to secure the caster wheels into place.
Installing and removing system components 83
To Next Page
Loading...
