Figure 104. Installing a drive into the drive carrier
Ne
xt steps
1. Install the drive carrier.
Removing the drive from the drive carrier
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Remove the drive carrier..
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
NOTE: If the drive carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screwdriver to
r
emove the drive.
2. Lift the drive out of the drive carrier.
I
nstalling and removing system components 157
To Next Page
Loading...
