Figure 118. Installing the NVMe drive bay blank
2. U
sing a Phillips #2 screwdriver, tighten the screws that secure the drive bay blank to the system.
Next steps
1. If removed, install the front bezel.
2. Replace the system cover.
3. Follow the procedure listed in After working inside your system.
Removing a drive bay
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure that is listed in Before working inside your system .
3. Remove all the drives.
4. Remove the backplane from drive bay.
Steps
1. Using the Phillips #2 screwdriver, remove the screws securing the drive bay to the system.
2. Slide the drive bay out of the system.
NOTE: The procedure to remove the drive bays is similar for all configurations.
168 Installing and removing system components
To Next Page
Loading...
