Figure 130. Installing the tape backup unit blank
Ne
xt steps
1. If removed, install the front bezel.
2. Follow the procedure that is listed in After working inside your system.
Removing the tape backup unit
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure that is listed in Before working inside your system .
3. Remove the air shroud.
4. If installed, remove the front bezel.
5. Disconnect the power and data cables from the tape backup unit.
NOTE: Ensure that you note the routing of the power and data cable on the side of the system as you remove them
f
rom the system board and drive.
Steps
1. U
sing a Phillips #2 screwdriver, remove the screw securing the tape backup unit to the system.
2. Slide the tape backup unit towards the front of the system.
178 Installing and removing system components
To Next Page
Loading...
