Figure 132. Installing the tape backup unit
Ne
xt steps
1. Connect the power cable and the data cable to the tape backup unit.
NOTE: Route the cables properly to prevent them from being pinched or crimped.
2. Install the air shroud.
3. If removed, install the front bezel.
4. Follow the procedure that is listed in After working inside your system.
Front IO module
This is a service technician replaceable part only.
Removing the front IO module
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure that is listed in Before working inside your system .
3. Remove the air shroud.
4. Remove the front bezel.
5.
Steps
1. Disconnect the power and data cables of the front IO module from the system board.
2. Pull the metal release bracket and slide the front IO module towards the front of the system.
180 Installing and removing system components
To Next Page
Loading...
