NOTE: If you assign a new system and/or setup password with the jumper on pins 4 and 6, the system disables the new
p
assword(s) the next time it boots.
5. Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.
6
. Power off the system.
7. Remove the system cover.
8. Move the jumper on the system board from pins 4 and 6 to pins 2 and 4.
9. Replace the system cover.
10. Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.
11. Assign a new system and/or setup password.
248 Jumpers and connectors
To Next Page
Loading...
