Dell PowerEdge T560 - Page 45

Table 34. 8 x 2.5-inch, 16 x 2.5-inch, 24 x 2.5-inch and 12 x 3.5-inch drive configuration
Standard Operating Support
(A
SHRAE A2 compliant)
Extended ambient 40° C Operating
Support (ASHRAE A3 compliant)
Extended ambient 45° C Operating
Support (ASHRAE A4 compliant)
● With STD Fans, the following OCP3.0
&
PCIe cards only support optic
cable with thermal Spec 85C and
power <=1.2W
○ Mellanox CX6 Lx 25GB 2P PCIe
card
○ Broadcom 25GB 4P SPF 57504
PCIe card
○ Intel 25GB 4P E810-CCV PCIe
card
○ Intel 25GB 2P XXV710 PCIe card
○ Intel 25GB 4P E810-XXV OCP
card
● D
oes not support 3x or 4x STD Fans
configs
● Does not support 8x STD fans
configurations with CPU Base TDP >
125W
● HPRx8 Fans configuration is required
to support BOSS M.2 Module
● Does not support TBU
● Does not support Non-Dell qualified
peripheral cards and Channel devices
(FW) cards
● Does not support PCIe card
consuming power >= 25W and
Mellanox CX6 Lx 25GB 2P PCIe card
● Does not support OCP transfer rate
>25G or cooling tier > 10
● Does not support GPU card
● Optic Cable with spec 85C is
required.
● D
oes not support STD fans configs
● Does not support 4x HPR fans config
with CPU Base TDP > 150W
● Does not support 8x HPR fans
configs with CPU Base TDP > 225W
● Does not support TBU
● Does not support BOSS M.2 Module
● Does not support Non-Dell qualified
peripheral cards and Channel devices
(FW) cards
● Does not support PCIe card
consuming power >= 25W and
Mellanox CX6 Lx 25GB 2P PCIe card
● Does not support OCP transfer rate
>25G or cooling tier > 10
● Does not support GPU card
● Optic Cable with spec 85C is
required.
Table 35. 8 x 3.5-inch + 8 x 2.5-inch NVMe drive configuration
Standard Operating Support
(A
SHRAE A2 compliant)
Extended ambient 40° C Operating
Support (ASHRAE A3 compliant)
Extended ambient 45° C Operating
Support (ASHRAE A4 compliant)
HPR fans are required.
● Two PSUs are required
● S
ystem performance may be reduced
in the event of a PSU failure
● Does not support TBU
● HPRx8 Fans configuration is required
to support BOSS M.2 Module
● Does not support Non-Dell qualified
peripheral cards and Channel devices
(FW) cards
● Does not support PCIe card
consuming power >= 25W and
Mellanox CX6 Lx 25GB 2P PCIe card
● Does not support OCP transfer rate
>25G or cooling tier > 10
● Does not support GPU card
● Optic Cable with spec 85C is
required
● T
wo PSUs are required. System
performance may be reduced in the
event of a PSU failure
● Does not support 4x HPR fans config
with CPU Base TDP > 150W
● Does not support 8x HPR fans
configs with CPU Base TDP > 225W
● Does not support TBU
● Does not support BOSS M.2 Module
● Does not support Non-Dell qualified
peripheral cards and Channel devices
(FW) cards
● Does not support PCIe card
consuming power >= 25W and
Mellanox CX6 Lx 25GB 2P PCIe card
● Does not support OCP transfer rate
>25G or cooling tier > 10
● Does not support GPU card
● Optic Cable with spec 85C is
required.
Technical specifications 45