Table 51. Network Settings details (continued)
Option Description
NVMe-oF Host Id This field specifies a 16 bytes value of the NVMe-oF host identifier
th
at uniquely identifies this host with the controller in the NVM
subsystem. Allowed input is a hexadecimal-encoded string in this format:
00112233-4455-6677-8899-aabbccddeeff. Leave it empty to use system
generated value. A value of all FF is not allowed.
Host Security Key Path This field specifies the Host security key path.
NVMe-oF SubSystem Settings This field controls the parameters for the NVMe-oF subsystem n
connections.
Table 52. PXE Device n Settings details
Option Description
Interface Specifies NIC interface used for the PXE device.
Protocol Specifies Protocol used for PXE device. This option is set to IP
v4 or IPv6. This option is set to
IPv4 by default.
VLAN Enables VLAN for PXE device. This option is set to Enabled or Disabled. This option is set to
Disabled by default.
VLAN ID Shows the VLAN ID for the PXE device
VLAN Priority Shows the VLAN Priority for the PXE device.
Table 53. HTTP Device n Settings details
Option Description
Interface Specifies NIC interface used for the HTTP device.
Protocol Specifies Protocol used for HTTP device. This option is set to IP
v4 or IPv6. This option is set
to IPv4 by default.
VLAN Enables VLAN for HTTP device. This option is set to Enable or Disable. This option is set to
Disable by default.
VLAN ID Shows the VLAN ID for the HTTP device
VLAN Priority Shows the VLAN Priority for the HTTP device.
DHCP Enables or disables DHCP for this HTTP device. This option is set to Enabled by default.
IP Address Specifies IP address for the HTTP device.
Subnet Mask Specifies subnet mask for the HTTP device.
Gateway Specifies gateway for the HTTP device.
DNS info via DHCP Enables or disables DNS Information from DHCP. This option is set to Enabled by default.
Primary DNS Specifies the primary DNS server IP address for the HTTP Device.
Secondary DNS Specifies the secondary DNS server IP address for the HTTP Device.
URI (will obtain from
DHCP server if not
specified)
Obtain URI from the DHCP server if not specified
TLS Authentication
Configuration
Specifies the option for TLS authentication configuration.
Table 54. ISCSI Device1 Settings screen details
Option Description
Connection 1 Enables or disables the iSCSI connection. This option is set to Di
sabled by default.
60 Pre-operating system management applications
To Next Page
Loading...
