PowerVault (Dell MD1400) Setup Guide
Install PowerVault without Encryption
This topic describes how to install a PowerVault without encryption on RSA Series 5 and Series
6 Decoder, Log Decoder, Concentrator, Archiver, and Hybrid physical hosts.
Prerequisites
Make sure that you have the following required software:
l For RSA NetWitness Platform 11.1.0.2 and later versions:
rsa-sa-tools-11.2.1.0-1901070555.5.d1d4cb3.el7.noarch.rpm or newer
version of this file, which contains the script you need to configure the storage.
l
For RSA Security Analytics 10.6.6.1 and later versions:
rsa-sa-tools-10.6.6.1-199.5.47209f4.el6.noarch.rpm or newer or newer
version of this file, which contains the script you need to configure the storage. This file is
available on RSA Link at https://community.rsa.com/docs/DOC-100361.
To verify the rsa-sa-tools version, log in as root on the physical hosts and run the following
command:
rpm -qa | grep sa-tools
Results example:
l For 11.x: rsa-sa-tools-11.2.1.0-1901070555.5.d1d4cb3.el7.noarch.rpm
l For 10.6.6.x: rsa-sa-tools-10.6.6.1-199.5.47209f4.el6.noarch.rpm
This RPM is updated quarterly. Contact RSA Customer Support to obtain the most recent
version.
l RSA NetWitness Platform - The minimum version is 10.6.6.0 (licensed only). The
recommended versions are 10.6.6.x and 11.1.0.2 and later.
To verify the version, in the Administration Services view (Administration > Services), the
release version is displayed to the right of each service listed. To check the version at the
command line, run the following command:
rpm -qa | grep nw
Results example:
nwconcentrator-10.6.6.2-182.3.0f6d16e.el6.x86_64
Caution: If you are adding a previously used PowerVault and would like to preserve the data,
DO NOT follow the instructions in this guide. Contact RSA Customer Support. Running the
script on a previously used PowerVault could erase any existing data.
Install PowerVault without Encryption 10
To Next Page
Loading...
