Dell PowerVault MD1400 - Restart Services for Hybrid Installation

PowerVault (Dell MD1400) Setup Guide
Restart the Services
You must restart the Log Hybrid or Network Hybrid services so that the services can recognize
the new volumes.
Note: If this physical host has a Log Decoder or (Network) Decoder service which is
currently capturing, it is a best practice to stop capture before restarting these services (to
ensure database writes are completed). If this physical host has a Concentrator or Archiver
service which is aggregating, it is recommended to stop aggregation before restarting these
services (to allow the indexes in memory to be saved to disk).
1. To restart the service, run the following commands using the appropriate service name for
your service.
l For Log Hybrid:
service <nwlogcollector, nwlogdecoder, nwconcentrator> stop (Wait
until this completes.)
service <nwlogcollector, nwlogdecoder, nwconcentrator> start
l For Network Hybrid:
service <nwdecoder, nwconcentrator> stop (Wait until this completes.)
service <nwdecoder, nwconcentrator> start
2.
Make sure that the service comes back online and begins capture.
a. In the NetWitness Platform Services view (Administration > Services or ADMIN >
Services), verify that the service status is green.
b.
Select the service and then select > View > System.
c. If you see the Start Capture or Start Aggregation icon in the toolbar, click the icon to
start it.
67 Install PowerVault on Core Appliance Used as a Hybrid