Dell PowerVault MD1400 - Attach and Configure PowerVault (No Encryption)

PowerVault (Dell MD1400) Setup Guide
Introduction
The following table contains the summarized installation instructions for different deployments,
and detailed procedures are in individual subsections. The deployment scenarios are:
l Multiple PowerVaults in a Concentrator, (Network) Decoder, Log Decoder, and Archiver
deployment.
l A single PowerVault in a Hybrid deployment.
Attach and Configure a PowerVault without Encryption
This table summarizes the steps you must complete to attach and configure a PowerVault
without encryption. The scenarios are shown in detail in the topics following immediately the
table.
NetWitness Platform 11.3 and Later
Deployment Scen-
ario
Tasks
Concentrator, Archiver,
Decoder, and Log
Decoder (Multiple Power-
Vaults)
1. Connect the PowerVaults to the physical host before powering
on the physical host as described in Connect PowerVaults to a
Concentrator, Archiver, Decoder, or Log Decoder Physical Host .
2. Follow the instructions in the Storage Guide for RSA
NetWitness Platform Version 11.3 and Later to allocate
storage for your hardware.
Hybrid
1. Connect the PowerVault to the physical host before powering
on the physical host as described in Connect a PowerVault to a
Hybrid .
2. Follow the instructions in the Storage Guide for RSA
NetWitness Platform Version 11.3 and Later to allocate
storage for your hardware.
11 Install PowerVault without Encryption