Dell PowerVault MD1400 - About this Document

PowerVault (Dell MD1400) Setup Guide
About this Document
This document provides instructions for installing a PowerVault external storage device on
RSASeries 5 and Series 6 (Network) Decoder, Log Decoder, Concentrator, Archiver, and
Hybrid hosts.
The hardware setup instructions in this document are for hardware only; they do not apply to a
specific release of RSA NetWitness Platform software. This document is for new hardware
only. It is not intended for PowerVaults with preexisting data.
The PowerVault installation script instructions in this guide apply only to NetWitness Platform
11.2 and earlier. For NetWitness Platform 11.3 and later, use the hardware connection
information in this guide, but refer to Storage Guide for RSA NetWitness Platform Version 11.3
and later for instructions on how to allocate storage for your hardware.
Caution: If you are adding a previously used PowerVault and would like to preserve the data,
DO NOT follow the instructions in this guide. Contact RSA Customer Support. Running the
script on a previously used PowerVault could erase any existing data.
Note: When viewing a printed guide, be aware that a newer version of the guide may be
available online at RSA Link in RSA NetWitness® Platform under Hardware Setup Guides:
https://community.rsa.com/community/products/netwitness/hardware-setup-guides
5 About this Document