PowerVault (Dell MD1400) Setup Guide
3. Connect the other end of the SAS cables to the External Storage units.
a. Connect the Primary Port 1 of the first PowerVault to Port 0 of the PERC Card on the
left using mini-to-mini SAS cables.
b. Daisy chain up to three additional PowerVaults to the first PowerVault using mini-to-
mini SAS cables.
c. Connect the Primary Port 1 of the first 15-Drive DAC to Port 0 of the PERC Card on the
right the using mini-to-SAS cables.
d. Daisy chain up to three additional 15-Drive DACs to the first 15-Drive DAC using mini-
to-SAS cables.
The following figure shows an RSA Series 5 (R630) host connected to four PowerVaults and
four 15-Drive DACs.
45 Install PowerVaults and 15-Drive DACs on a Series 5 or Series 6 Host (Mixed
Mode)
To Next Page
Loading...
