PowerVault (Dell MD1400) Setup Guide
5. To run the NwArrayConfig.py script using the default parameters, use one of the following
commands.
For RSA NetWitness Platform versions 10.6.6.1-199.5.47209f4 or later, run the following
command:
./NwArrayConfig.py
For RSA NetWitness Platform 11.2.0.0-1808301802.5.941817f and later, run the following
command:
OWB_ALLOW_NON_FIPS=1 ./NwArrayConfig.py
[root@P<hostname> saTools]#
This script discovers all available PowerVaults; creates all the necessary virtual drives,
logical volumes, and the directory structure; and writes the debug messages to
/opt/rsa/saTools/arrayCfg.log. On a Log Decoder and (Network) Decoder host, this script
adds the database types of packetdb, metadb, and sessiondb.
Install PowerVaults and 15-Drive DACs on a Series 5 or Series 6 Host (Mixed
Mode)
52
To Next Page
Loading...
