PowerVault (Dell MD1400) Setup Guide
Series 5 - R630 Host
The following figure shows an R630 host (port 0 ) connected to a PowerVault (port 1 in
top row of ports) using a mini-to-mini SAS cable.
The PERC830 card for the R630 is installed in slot #3. This means that:
l Port 0 is on the left and port 1 is on the right on the R630.
l You must attach the cable to the R630 with the connector's blue tab on the top.
l You must attach the other end the cable to the PowerVault with the connector's blue
tab on the top.
l You know if the cable is properly connected when you hear a click as the cable locks
into place and see the green port light illuminate on the R630.
Install PowerVault on Core Appliance Used as a Hybrid 60
To Next Page
Loading...
