EasyManuals Logo

Dell PowerVault NX3100 User Manual

Dell PowerVault NX3100
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #119 background imageLoading...
Page #119 background image
Installing System Components 119
CAUTION: To prevent damage to the drives and backplane, you must remove the
hard drives from the system before removing the backplane.
CAUTION: You must note the number of each hard drive and temporarily label
them before removal so that you can replace them in the same locations.
4
Remove all hard drives. See "Removing a Hot-Swap Hard Drive" on
page 70.
5
Disconnect the power cable from the end of the SAS backplane.
6
Disconnect the SAS data cables from the backplane.
7
Disconnect the optical-drive cable, USB cable, internal hard-drive cables,
and the control-panel cable.
CAUTION: Handle the cables gently to prevent damage.
8
While pressing the two blue latches toward each other, lift the backplane
upward. See Figure 3-24.
9
When the backplane cannot slide upward any farther, pull the backplane
toward the back of the system to remove it from the retention hooks.
10
Lift the board out of the system, being careful to avoid damaging
components on the face of the board.
11
Place the SAS backplane face down on a work surface.
book.book Page 119 Wednesday, March 3, 2010 10:37 AM

Table of Contents

Other manuals for Dell PowerVault NX3100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell PowerVault NX3100 and is the answer not in the manual?

Dell PowerVault NX3100 Specifications

General IconGeneral
BrandDell
ModelPowerVault NX3100
CategoryServer
LanguageEnglish

Related product manuals