About this task
The following images indicate the location of the power-supply unit and provide a visual representation of the installation
procedure.
Steps
1. Slide the cover into the chassis until the securing tab snaps into position.
2. Replace the two (M6x32) screws to secure the cover to the power supply unit.
3. Connect the power cable to the connector on the cover.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
Removing the 500 W power-supply unit
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the power-supply unit cover.
NOTE:
Note the routing of all cables as you remove them so that you can route them correctly while you are replacing the
power-supply unit.
48 Removing and installing components
To Next Page
Loading...
