About this task
The following images indicate the location of the power-supply unit and provide a visual representation of the removal
procedure.
Steps
1. Lay the computer on the right side.
2. Disconnect the power cables from the connectors on the system board and unroute them from the routing guides on the
chassis.
3. Remove the four (M6x32) screws that secure the power-supply unit to the chassis.
4. Slide the power-supply unit away from the back of the chassis.
5. Lift the power-supply unit off the chassis.
Installing the 750 W/1000 W power-supply unit
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components
53
To Next Page
Loading...
