3. Tighten the four captive screws that secure the VR heat sinks to the system board.
Next steps
1. Close the PSU cage
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Chassis fan
Removing the front fan
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the chassis fan and provide a visual representation of the removal procedure.
Steps
1. Disconnect the fan cable from the connector on the system board.
2. Press the tab to release the chassis fan from the slot.
3. At an angle lift the chassis fan and remove it from the chassis.
62
Removing and installing components
To Next Page
Loading...
