Steps
1. Place the battery onto its slot in the palm-rest and keyboard assembly.
2. Replace the five (M2x4) screws that secure the battery to the palm-rest and keyboard assembly.
3. Route the WLAN antennas using the routing guides on the battery.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
M.2 solid-state drive
Removing the M.2 2230 solid state drive
Prerequisites
NOTE: For computers shipped with M.2 2230 solid state drive.
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The figure indicates the location of the M.2 2230 solid state drive and provides a visual representation of the removal
procedure.
20
Removing and installing components
To Next Page
Loading...
