Steps
1. Align and place the smart-card reader into its slot on the palm-rest and keyboard assembly.
2. Replace the two (M1.6x1.7) screws to secure the smart-card reader to the palm-rest and keyboard assembly.
3. Adhere the smart-card reader FFC to the palmrest and keyboard assembly.
4. Connect the smart-card reader FFC to the connector on the USH board.
Next steps
1. Install the speakers.
2. Install the battery.
3. Install the base cover.
4. Follow the procedure in after working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The figure indicates the location of the display assembly and provides a visual representation of the removal procedure.
38
Removing and installing components
To Next Page
Loading...
