Steps
1. Remove the three (M1.6x2) screws that secure the fingerprint-reader bracket to the power-button board.
2. Remove the fingerprint-reader bracket from the power-button board.
3. Remove the power-button board with power-button FPC from the palm-rest and keyboard assembly.
Installing the power-button board with fingerprint reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the power-button board with fingerprint reader and provides a visual representation of the
installation procedure.
50
Removing and installing components
To Next Page
Loading...
