Steps
1. Align and place the audio jack in its slot on the palm-rest and keyboard assembly.
2. Connect the audio jack FPC to its connector on the system board.
3. Replace the (M1.6x3) screw to secure the audio jack to the system board.
4. Align and place the left USB Type-C bracket on the system board.
5. Replace the three (M2x4) screws that secure the left USB Type-C bracket to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Speakers
Removing the speaker
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The figure indicates the location of the speaker and provides a visual representation of the removal procedure.
34
Removing and installing components
To Next Page
Loading...
