Next steps
1. Install the heat sink for integrated graphics or heat sink for discrete graphics.
2. Install the audio jack.
3. Install the right fan.
4. Install the left fan.
5. Install the battery.
6. Install the M.2 2230 solid state drive or M.2 2280 solid state drive.
7. Install the base cover.
8. Follow the procedure in after working inside your computer.
Power button with fingerprint reader
Removing the power-button board with fingerprint reader
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the M.2 2230 solid state drive or M.2 2280 solid state drive.
4. Remove the battery.
5. Remove the left fan.
6. Remove the right fan.
7. Remove the audio jack.
8. Remove the display assembly.
9. Remove the system board.
NOTE:
The system board can be removed or installed together with the heat sink attached. This simplifies the
procedure and avoids breaking the thermal bond between the system board and the heat sink.
About this task
The figure indicates the location of the power-button board with fingerprint reader and provides a visual representation of the
removal procedure.
Removing and installing components
49
To Next Page
Loading...
