Installing the palm-rest and keyboard assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the palm-rest and keyboard assembly and provides a visual representation of the installation
procedure.
Steps
1. Place the palm-rest assembly on a flat surface.
2. Perform the steps in the post-requisites.
Next steps
1. Install the WLAN antennas.
2. Install the power-button board with finger print reader.
3. Install the system board.
4. Install the display assembly.
5. Install the speakers.
6. Install the audio jack.
7. Install the right fan.
8. Install the left fan.
9. Install the battery.
10. Install the M.2 2230 solid state drive or M.2 2280 solid state drive.
11. Install the base cover.
12. Follow the procedure in after working inside your computer.
Removing and installing components
57
To Next Page
Loading...
